Filter, Gelatin, w/o Support Pad, 25mm, 50Pk

Part Number:

225-9551

- +
Overview
Presterilized gelatin (water soluble) filter, 25-mm, no support pad included, recommended for use with Button Sampler.
Pre-sterilized, high-moisture Gelatin Filters help to maintain microorganism viability for sampling periods up to 30 minutes. Gelatin Filters dissolve easily when placed on agar and can be used to monitor in areas where disinfectants or antibiotics are present.
Attributes
MaterialGelatin
Diameter25-mm
AutoclavableNo
Special FeaturesFilters only; pre-sterilized by gamma irradiation
 

Performance Profile

MaterialWater-soluble gelatin
Pore SizeWhile having a nominal pore size of 3 µm, a higher capture efficiency of sub-micron particles can be expected due to the separations that occur on the surface and within the filter. It is through inertial impaction and diffusional interception that these filters can remove particles much smaller that 3 µm.
Diameter25 mm or 37 mm
ThicknessApproximately 250 µm
SterilizationPresterilized by gamma radiation. Filters individually wrapped and packaged in units of five each in a polyethylene bag
Thermal ResistanceMaximum 140 F (60 C)
Residual Dampness Content46 to 49%
Conditions for UseMaximum room temperature is 86 F (30 C); maximum relative humidity is 85%.
Sampling Time30 minutes at typical indoor relative humidity
Sampling Flow Rate

1 to 4 L/min for filter sampling of biological contaminants using a standard filter cassette, Button Sampler, or the IOM

StorageGelatin filters may be stored in low humidity, ambient conditions; storage between 39.2 and 46.4 F (4 and 8 C) is recommended.
Caution: Do not store gelatin filters below 39.2 F (4 C). Condensation during thawing will dissolve filter. Avoid exposing filters to moisture, chemical vapors, and extreme temperatures.
Shelf-life3 years from date of manufacture
AnalysisDirect method or indirect method. Gelatin filters dissolve when placed on agar plates.