SKC EPA Sampling Guide for Tetrahydrofuran
| Chemical Information | |
Tetrahydrofuran 109-99-9 | TD, GC Internal |
| Sampling Parameters | |
Ambient 17.7 ml/min | 8-24 hrs |
| Important Information Outdoor sampling rates are shown. |
SKC Sampling Equipment
ULTRA® Passive Sampler for sub-ppb level VOCs and SVOCs, Anasorb GCB1, 5PkPart Number: 690-101$348.00 /PKULTRA® Passive Sampler for sub-ppb level VOCs and SVOCs, prefilled with Anasorb GCB1 (comparable to Carbopack B), 60/80 mesh, 370 mg in each compartment, with built-in blank.
ULTRA® Passive Sampler for sub-ppb level VOCs and SVOCs, Chromosorb 106, 5PkPart Number: 690-103$293.00 /PKULTRA® Passive Sampler for sub-ppb level VOCs and SVOCs, prefilled with Chromosorb 106 (additional sampling rate info available), 20/40 mesh, 285 mg in each compartment, with built-in blank.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login