SKC HSE Sampling Guide for bis-2-Ethylhexyl phthalate (dioctyl phthalate)
| Chemical Information | |
Ethylhexyl phthalate (dioctyl phthalate) 117-81-7 | GC-FID OSHA 104 |
| Sampling Parameters | |||
TWA 5 mg/m3 | 240 | 1000 | 4 |
| Important Information Use two 226-35 tubes |
SKC Sampling Equipment
OVS Sorbent Tube, Tenax TA sorbent w/Glass Fiber Filter, 13 to 8 x 75-mm size, 2 sections, 140/70 mg, 20/35 mesh, 10PkPart Number: 226-56$264.00 /PKOVS Sorbent Tube, Tenax TA sorbent, 20/35 mesh, 2 sections, 140/70 mg, and glass fiber filter inside a 13➞7 x 60-mm size glass tube; for explosives-TNT and DNT (OSHA 44), phthalate esters (OSHA 104), and acrylates and benzophenone (non-agency method 39). Tube Ends: Glass Open Separators: PTFE Ring/Glass Fiber Filter/Foam/Foam
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login