SKC HSE Sampling Guide for Hydrogen sulphide
| Chemical Information | |
Hydrogen sulphide 7783-06-4 | IC OSHA 1008 |
| Sampling Parameters | |||
TWA 5 ppm (7 mg/m3) | |||
SKC Sampling Equipment
Sorbent Tube, Silica Gel, treated w/silver nitrate, glass fiber filter treated w/sodium carbonate/glycerol, 16 to 8-mm OD x 85-mm length, 2 sections, 200/200 mg sorbent, 20/40 mesh, 5PkPart Number: 226-177$268.00 /PKSorbent Tube, for hydrogen sulfide, silica gel coated with silver nitrate and a glass fiber filter treated with sodium carbonate/glycerol, 16 to 8-mm OD x 85-mm length, 2 sections, 200/200 mg sorbent, 20/40 mesh. Meets the specification of new OSHA Method 1008 for Hydrogen Sulfide and Method 1011 for Sulfur Dioxide Tube Ends: Glass Open Separators: PTFE Ring/PTFE Ring/PTFE Ring/Glass Wool/Glass Wool
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login