SKC HSE Sampling Guide for N-Methylaniline

SKC HSE Sampling Guide for N-Methylaniline
Chemical Information
Methylaniline
100-61-8
GC-FID
NIOSH 3511
Sampling Parameters

TWA 0.5 ppm (2.2 mg/m3)

100

1000

100 min

SKC Sampling Equipment

Impinger:
  1. Midget Impinger, Glass, 25 ml, Fritted Nozzle
    Part Number: 225-36-2
    $151.00 /EA
    Glass Midget Impinger, 25 ml, with fritted nozzle
  2. Midget Impinger, Glass, 25 ml, Fritted Nozzle, Spill-resistant
    Part Number: 225-36-5
    $197.00 /EA
    Glass Spill-resistant Midget Impinger, 25 ml, with fritted nozzle
Impinger Trap:
  1. Impinger Trap, Glass, Each
    Part Number: 225-22
    $82.00 /EA
    Glass Trap for Glass Midget Impingers, for area sampling, can be used with or without sorbent.

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.