SKC OSHA / NIOSH Sampling Guide for Carbon monoxide

SKC OSHA / NIOSH Sampling Guide for Carbon monoxide
Chemical Information
Carbon monoxide
630-08-0
GC-DID
Qualitative: 0.12 ppm (1 ml gas sample) Quantitative: 0.40 ppm (1 ml gas sample)
Sampling Parameters

TWA 50 ppm
C/STEL

2 - 5 L
2 - 5 L

10 - 50 ml/min
1000 ml/min

varies
varies

Important Information
Additional bag sizes/volumes are available on the SKC website. Select based on your application.

SKC Sampling Equipment

Sample Bag:
  1. FlexFoil PLUS Sample Bag w/Single Polypropylene Septum Fitting, 1L, 10Pk
    Part Number: 252-01
    $162.00 /PK
    FlexFoil® PLUS 1-liter Sample Bag with single polypropylene septum fitting which combines the hose/valve and the septum holder into one compact fitting.
  2. FlexFoil PLUS Sample Bag w/Single Stainless Steel Septum Fitting, 1L, 10Pk
    Part Number: 253-01
    $238.00 /PK
    FlexFoil® PLUS 1-liter Sample Bag with single stainless steel septum fitting.
  3. FlexFoil Sample Bag w/Single Polypropylene Septum Fitting, 1L, 10Pk
    Part Number: 262-01
    $144.00 /PK
    Standard FlexFoil® 1-liter Sample Bag with single polypropylene septum fitting which combines the hose/valve and the septum holder into one compact fitting.
  4. FlexFoil Sample Bag w/Single Stainless Steel Septum Fitting, 1L, 10Pk
    Part Number: 263-01
    $229.00 /PK
    Standard FlexFoil® 1-liter Sample Bag with single stainless steel septum fitting.
Pumps:
  1. Pocket Pump TOUCH Pump
    Part Number: 220-1000TC
    $806.00 /EA
    Pocket Pump® TOUCH with Li-Ion battery and screwdriver. Requires charger. Requires 877-94 to use Bluetooth with PC.

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.