SKC OSHA / NIOSH Sampling Guide for Hydrogen cyanide

SKC OSHA / NIOSH Sampling Guide for Hydrogen cyanide
Chemical Information
Hydrogen cyanide
74-90-8
IC-ELCM
 
Sampling Parameters

TWA 10 ppm
C/STEL


28.4 ml/min

8 hr
15 min

SKC Sampling Equipment

Passive Sampler:
  1. Hydrogen Cyanide Passive Sampler, Soda Lime, 5Pk
    Part Number: 590-400
    $348.00 /PK
    Hydrogen Cyanide Passive Sampler, Soda Lime, 600 mg, includes empty sampler housing and sealed 4-ml glass vial of 600 mg soda lime sorbent. Specified in OSHA Method 1015 for hydrogen cyanide.

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.