SKC OSHA / NIOSH Sampling Guide for Vinyl chloride
| Chemical Information | ||
Vinyl chloride 75-01-4 | GC-FID | |
| Sampling Parameters | |||
TWA | 24 L | 100 - 50 ml/min | 4 or 8 hr |
| Important Information ASTM D 4766 specifies a TWA sample only for a 4-hour run time at 100 ml/mn or an 8-hour run time at 50 ml/min |
SKC Sampling Equipment
Sorbent Tube, Anasorb CSC (Coconut Shell Charcoal), 10 x 110-mm size, 2 sections, 800/200 mg sorbent, 20/40 mesh, 50PkPart Number: 226-16$151.00 /PKSorbent Tube, Anasorb CSC, Coconut Shell Charcoal, 10 x 110-mm size, 2 sections, 800/200 mg sorbent, 20/40 mesh. Tube Ends: Glass Sealed Separators: Glass Wool/Glass Wool/Foam
Pocket Pump TOUCH PumpPart Number: 220-1000TC$806.00 /EAPocket Pump® TOUCH with Li-Ion battery and screwdriver. Requires charger. Requires 877-94 to use Bluetooth with PC.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login