SKC OSHA / NIOSH Sampling Guide for Carbon disulfide
| Chemical Information | ||
Carbon disulfide 75-15-0 | GC-FPD | 0.02 mg/sample |
| Sampling Parameters | |||
TWA 1 ppm | 2 - 25 L | 10 - 200 ml/min | varies |
SKC Sampling Equipment
Sorbent Tubes, Anasorb CSC, Coconut Charcoal, pk/50Part Number: 226-01$50.00 /PKSKC offers a complete selection of sorbent tubes designed specifically for solvent extraction specified in many OSHA, NIOSH, ASTM, EPA, and non-agency methods. Quality SKC Sorbent Tubes feature consistent sorbent mesh size, validation, and over 45 years of proven performance.
Sorbent Tube, Drying Tube, 6 x 70-mm size, 1 section, 250 mg sorbent, 10/60 mesh, 50PkPart Number: 226-44$154.00 /PKSorbent Tube, Drying Tube, 6 x 70-mm size, 1 section, 250 mg sorbent, 10/60 mesh. Tube Ends: Glass Sealed Separators: Glass Wool/Glass Wool
Pocket Pump TOUCH PumpPart Number: 220-1000TC$806.00 /EAPocket Pump® TOUCH with Li-Ion battery and screwdriver. Requires charger. Requires 877-94 to use Bluetooth with PC.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login