SKC OSHA / NIOSH Sampling Guide for Fluorine
| Chemical Information | ||
Fluorine 7782-41-4 | ISE | 25 ug (25 ml sample solution volume) |
| Sampling Parameters | |||
TWA 0.1 ppm | 480 L | 1000 ml/min | |
| Important Information ^ Fill impinger with 15ml of 0.1 N NaOH. Sample will be analyzed for total fluoride using Method ID-110 and the result will be reported as fluorine. |
SKC Sampling Equipment
Midget Impinger, Glass, 25 ml, Fritted NozzlePart Number: 225-36-2$151.00 /EAGlass Midget Impinger, 25 ml, with fritted nozzle
Impinger Trap, Glass, EachPart Number: 225-22$82.00 /EAGlass Trap for Glass Midget Impingers, for area sampling, can be used with or without sorbent.
AirChek TOUCH PumpPart Number: 220-5000TC$1,208.00 /EAAirChek® TOUCH AirChek Pump with Li-Ion battery pack and screwdriver set. Requires charging cradle and power supply. Connectivity to PC requires 877-93. Low flows from 5 to 500 ml/min require a low flow kit. AirChek TOUCH pumps contain Li-Ion batteries and are subject to special shipping regulations. AirChek TOUCH requires ¼-inch ID tubing.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login