SKC OSHA / NIOSH Sampling Guide for Naphthylamines (alpha- & beta-)

SKC OSHA / NIOSH Sampling Guide for Naphthylamines (alpha- & beta-)
Chemical Information
Naphthylamines (alpha- & beta-)
134-32-7 & 91-59-8
GC-FID
0.01 µg/sample
Sampling Parameters

TWA
C/STEL

30 @0.5ug/m3 - 100 L

200 - 800 ml/min

varies

SKC Sampling Equipment

Filter:
  1. Filter, Glass Fiber Type AE, w/o Support Pad, 1.00 µm, 13mm, 500Pk
    Part Number: 225-16
    $95.95 /PK
    Glass Fiber Filter, Type A/E, 1.0 µm liquid nominal pore size, 13-mm, binder-free, no support pad included; for gravimetric analysis of air pollutants and testing dissolved/suspended wastewater solids.
Filter Cassette:
  1. Filter Holder, Swinnex (polypropylene) with silicone seal, reusable, autoclavable with filter in place, 13mm, 2-Pieces, 10Pk
    Part Number: 225-32
    $191.10 /PK
    Filter Holder, polypropylene (Swinnex), with silicone seal, reusable, autoclavable with filter in place, 13-mm, 2-Pieces
Sorbent Tube:
  1. Sorbent Tube, Silica Gel, 6 x 70-mm size, 2 sections, 100/50 mg sorbent, 20/40 mesh, 50Pk
    Part Number: 226-51
    $132.00 /PK
    Sorbent Tube, Silica Gel, 6 x 70-mm size, 2 sections, 100/50 mg sorbent, 20/40 mesh. Tube Ends: Glass Sealed Separators: Foam/Glass Wool/Glass Wool
Pumps:
  1. Pocket Pump TOUCH Pump
    Part Number: 220-1000TC
    $806.00 /EA
    Pocket Pump® TOUCH with Li-Ion battery and screwdriver. Requires charger. Requires 877-94 to use Bluetooth with PC.

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.