SKC Passive Sampling Guide for o-Xylene
| Chemical Information | |||||||||
o-Xylene 95-47-6 |
| ||||||||
| Sampling Parameters | |
14.24 15 | 8 |
| Method Parameters | ||
GC-FID 89.4 | Carbon disulfide (2 ml) |
|
| Important Information Sampling rate generated by OSHA SLC Tech Center. SKC in-house validation produced a similar sampling rate. SKC recommends using the OSHA rate for compliance sampling. |
SKC Sampling Equipment
VOC Chek 575 Passive Sampler, for ppm-Level Organic Vapors, Anasorb 747, 5PkPart Number: 575-002$98.00 /PKVOC Chek® 575 Passive Sampler for ppm-level organic vapors, contains Anasorb 747, 500 mg. Larger package sizes are available. See 575-002A, 575-002B, 575-002C.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login