SKC OSHA/NIOSH/ASTM Sampling Guide for 2, 4- TDI (toluene diisocyanate) (isocyanates, total)
Chemical Hazard
2, 4- TDI (toluene diisocyanate) (isocyanates, total)
CAS. No.
584-84-9
Sampling Methodology
Sampling Parameters
Agency Standards (ppm) |
Volume |
Rate |
Time |
|---|---|---|---|
|
TWA LFC |
1-500 L |
1000-2000 ml/min |
varies hrs |
Analytical Method
HPLC-UV
SKC Sampling Equipment
Filter:225-7
Filter Cassette :225-4
Support Pads:225-27 or
IOM Particulate Sampler:225-76A
Filter:225-702
Air Sampling Pump:220-5000TC
Limit of Detection
0.2 nmole NCO/species/sample
Footnotes
Filters must be chemically treated.Sampler may be either 37 mm GF filter w/cellulose support or SS IOM w/25 mm GF filter or impinger.
The MOPIP Derivatizing Solution, Cat. No. 225-9050, is needed to analyze for monomer/oligomer aerosol.
This SKC Air Sampling guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.