SKC OSHA / NIOSH Sampling Guide for Hydrogen sulfide

SKC OSHA / NIOSH Sampling Guide for Hydrogen sulfide
Chemical Information
Hydrogen sulfide
7783-06-4
GC-FPD
 
Sampling Parameters

TWA
C/STEL

12 L

1000 ml/min

12 min

Important Information
NON 42: National Council of the Paper Industry for Air and Stream Improvement (NCASI) Technical Bulletin No. 656, December 1993

SKC Sampling Equipment

Sample Bag:
  1. Tedlar® Sample Bag w/Dual Stainless Steel Fitting, 10L, 10Pk
    Part Number: 231-10
    $350.00 /PK
    Tedlar® 10-liter Sample Bag with dual stainless steel fittings: the hose/valve for flushing, filling, and sealing the bag, and the septum with a syringe port for removing samples for analysis.
Pumps:
  1. Pocket Pump TOUCH Pump
    Part Number: 220-1000TC
    $806.00 /EA
    Pocket Pump® TOUCH with Li-Ion battery and screwdriver. Requires charger. Requires 877-94 to use Bluetooth with PC.

This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.