SKC OSHA / NIOSH Sampling Guide for Radon progeny (on dust, in mines)
| Chemical Information | ||
Radon progeny (on dust, in mines) | DRI | |
| Sampling Parameters | |||
TWA | 5 L | 2000 ml/min | 5 min |
| Important Information NON 56: MSHA Handbook Number PH06-IV-1(1) Metal and Nonmetal Mine Safety and Health MSHA Handbook Series U.S. Department of Labor Mine Safety and Health Administration U.S. Department of Labor October 2006 A |
SKC Sampling Equipment
Filter, Glass Fiber Type A/E, w/o Support Pad, 310 to 350 µm thick, 1.00 µm, 25mm, 500PkPart Number: 225-702$99.95 /PKGlass Fiber Filter, Type A/E, 1.0 µm, 25-mm, no support pad included, 310 to 350 µm thick, binder-free; recommended for use with Button Sampler.
Filter Holder, Delrin® (acetal resin), 25-mm open-face design w/ stainless steel screen and one 1/4-inch ID nylon hose barb, 6PkPart Number: 225-1107$371.00 /PKFilter Holder, Delrin® (acetal resin), 25-mm open-face design, with stainless steel screen and one 1/4-inch ID nylon hose barb.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login