SKC Passive Sampling Guide for Sulfur dioxide
| Chemical Information | |||||||||
Sulfur dioxide 7446/9/5 |
| ||||||||
| Sampling Parameters | |
15.2 15 | 24 |
| Method Parameters | ||
IC 97.8 | Partial De-ionized water (2 ml) | |
| Important Information # NIOSH STEL level Tape is desorbed with 2 ml of de-ionized DIUF water. Refer to the operating instructions for details # - NIOSH STEL level |
SKC Sampling Equipment
UMEx 200 Passive Sampler for Sulfur Dioxide and Nitrogen Dioxide, 10PkPart Number: 500-200$190.00 /PKUMEx 200 Passive Sampler, for sulfur dioxide and nitrogen dioxide, with validated concentration range of 0.4 to 8 ppm for SO2 and 0.05 to 8 ppm for NO2; single use only.
This SKC Air Sampling Guide is a reference only to assist users in finding the method, sampling equipment, and sampling media for a specific compound. This publication is intended for general information only and should not be used as a substitute for reviewing applicable government regulations, equipment operating instructions, or legal standards. Users must consult the appropriate sampling method for the compound of interest before sampling. The sampling parameters shown here are suggestions based on the ranges or volume, flow, and time specified in the methods. It is the responsibility of the analyst performing the sampling and analysis steps to adjust the parameters so that the required detection limits can be obtained. The information contained in this document should not be construed as legal advice or opinion nor as a final authority on legal or regulatory procedures.
Validate your login